My school has an ETC Idea 24 Light board to run our stage lights. And its able to be hooked up to a VGA montitor. But some stupid person took out the cabel. Any ways I need a new cable. Can you please look at the link at photos of the mother board and tell me where it gets pluged in and what cords I need. If you can help me that would be great!!!
None of the pictures had pictures of a connection to a VGA monitor. Although the first one looked like it had a connection at the top of the picture poking out of the case. It is at the top of the picture directly in the center.
That is either the VGA connection, or it could be a serial connection. Besides this, I didn't see anything where you could plug in a monitor.
I got a 99 Chevy Silverado 4x4 which I'm slowy adding more and more into. Curently, I'm on the Neon stage. I work at Autozone, which gives me an upper hand, so we got all the Neon kits. I was browsing on some of these and discovered a neon bar that connects to the lighter, which I didn't like, and a LED. The LED connects to the Battery or something that has a 12v conection. So me and a co-worker started talking about this and we came to the conclusion that I should connect it using a fuse adapter to which the radio fuse and an extra fuse + cable can connect to. So that is what I thought, also, I'm probably going to use a switch as to not keep the light on all the time, and third, what is a good place to put this bar?
PS- Is there a limit to how many lights I can put before the battery gets affected?
the leds dont use a lot of power so you will be ok.you can mount it under the dash,above or below the back window,in the grill,in between the tailgate and bumper (used as a 3rd brake light)and led is the better way to go than neons (last longer & brighter)yes you can wire it up the way you were suggesting.
